Product Description
Function:
add sustain, string stay locked and in tune
stabilize your floating tremolo bridge in tune
Specification:
made of brass,
measurements is 58x19x15mm,
weight 39g
Package:
1 x LAMSAM tremsetter bridge tremolo stabilizer
4 x mounting screws
1 x wrench
Setup Steps for reference only:
1. get guitar in tune as best as possible (includes the intonation adjustment), guitar nut locked
2. make sure the bridge was parallel with the guitar body and still in tune, to insure the tension is correct
3. make sure the tip of tremolo stabilizer toutch the floating tremolo block and no pressure on the system
4. hand-drill pilot holes oin the guitar body and start from the holes closest to the trem block,always make sure the stabilizer tip toutch the block
5. adjust the counter pressure with the springs after the stabilizer installed (make sure to keep guitar bridge leveled)
6. turn the SPRING CLAW SCREWS into the Guitar and tighten,JUST A LITTLE EACH!
7. turn the brass nut behind the Stabilizer tip back and tighten the Stabilizers spring a little.
8. Getting balance between that Stabilizer Spring and the Trems Springs is a juggling act
9. If there is Friction squeak. DO NOT USE OIL.just melt some bee wax and drip at that contact point between the Stabilizer tip and the Trem Block
Remark:
the above step just for reference, since different component may varies
always make sure the bridge is level and guitar in tune
Never drill through guitar compoents
the stabilizer is toutching the block